ADU 5

ECUMASTER ADU is an advanced Display Unit

Our Advanced Display Units 5”  features high resolution, high visibility anti-glare screess, guaranteeing perfect visibility in any lighting conditions. The ADU comes with multiple pre-configured pages, which can be customized by the end user to display data required at every race stage.

The ADU is also equipped with 15 ultra-bright RGB LEDs which can be used as an advanced gear-dependent shift light and can be modified by user-defined logic (for alarms, low fuel level, etc.).

Communication with other devices in the car is provided via two built-in, independent CAN-BUS communication ports. CAN templates are provided for most popular ECUs, and are fully configurable, allowing you to connect our hardware to virtually any engine management system.

GENERAL

Temperature range: AECQ100 GRADE3 (-40 to +85˚C)

Reverse battery protection: Yes, internal

Operating voltage: 6-22V, immunity to transients according to ISO 7637

Enclosure: Rev.1 ->IP 60, custom CNC machined aluminum

                        Rev.2 ->IP 65, custom CNC machined aluminum (sealed)

Connectors: 1 x 35 positions, AMP Automotive connector

PC communication: CAN BUS – Ecumaster interface, Peak or Kvaser

Display Type:   TFT 800×480

Brightness of display: 5″ – 600 cd/m2, 7″ – 1000 cd/m2

INPUTS / OUTPUTS

Analogue inputs: 8 inputs, 10 bits, 0-5 V, software controlled pull-up/pull-down 10K resistor. Al analog inputs can be used as a switches

Digital inputs: 8 digital inputs, software controlled input sensitivity (VR, Hall), software controlled 4K7 pull-up resistors, used for engine speed sensors, Flex Fuel, wheel speeds, turbocharger shaft speed. All digital inputs can be used as switches

Outputs 2 low side outputs (switch to ground), up to 2A, 1 analogue output (0-5V) 10 bits

+5V Output Monitored 5V output for powering external sensors

COMMUNICATION

CAN Interface: 2 x CAN2.0 A/B, 250, 500, 1000 Kbps

CAN streams: User-defined

Serial communication: RS232 Rx/Tx, AiM protocols, Ecumaster, Hondata Kpro, Autronic

USB: Used for logging to external USB memory

OTHERS

Light Emitting Diodes: 15 ultra bright RGB LEDs

Accelerometer/gyroscope: 3D accelerometer + 3D gyroscope for the analysis of vehicle dynamics

Real-time clock: Yes, battery powered

Light sensor: Yes, for automatic correction of brightness

Temperature sensor: Yes, for monitoring device temperature