Digital ECU Tuner 3

Digital ECU Tuner 3 je nejpopulárnější zařízení typu "piggy back" na trhu. Díky svých vlastnostem a atraktivní ceně se skupina skupina spokojených zákazníků stále rozrůstá.

Technické detaily:

• four 16x16 side tables (fuel map,two PWM tables, ignition table),
• 8 Correctiontables 16x1,
• 2 independent switchable map sets ,
• possibility modification of one analogue signal,
• 4 analogueinputs,
• inbuilt Data Flash ? possibility of logging without connected PC,
• battery voltage monitoring ,
• support of frequency output air flow meter (possibility of signal modification) 17Hz-4kHz,
• support VR and Hall effect crank sensors together with ignition modules pulse. Device supportbothsingle ended and differential signals,
• supports a lot of crank trigger patterns :60-2, 36-2, 36-1, Multitooth, Ignition Modules and more,
• support of waste gate valve,
• output for 4 saturated injectors ("full group"),
• ON/OFF parametricoutput,
• automatic conversion of MAP to MAF with the use of the learning algorithm,
• launch control,
• road dyno,
• possibility individual calibration of each analogue sensors ? device displayed values with correct units,
• free firmware update ? new crank trigger patterns and new functionality,
• fuel Implant mode ?possibility of drive injectors in standalone mode (batch fire),
• USB communication no additional interface needed,
• 24 months warranty.

PC Requirements:

To properly work with the DET3 device following minimum is required.

• Windows 2000, XP, Vista, Windows 7, Windows 8
• Screen resolution of at least 1024x768 16bit
• CPU with a clock of at least 600MHz,
• USB port.

Co najdete v balení

• Digital Ecu Tuner 3 zařízení,
• USB AA kabel,
• konektor,
• set kontaktů do konektoru,
• CD se softwarem,  potřebné ovladače a uživatelský manual,
• sada resistorů a diody užitečných při instalaci.